ANALISA KEKERASAN MATA PISAU BAHAN ST 60 PADA MESIN PEMOTONG ZINCALUME DENGAN PROSES PERLAKUAN PANAS (HEAT TREATMENT)
Sari
incalume cutting machine is the right machine to accelerate a production in a cutting system by using the main tool of an electric motor. In this study testing of the blades for cutting zincalume, in this test heat treatment (Heat Treatment) is done by cooling used oil to find out the hardness of the blade. Subsequent testing includes, among others: Hardness Testing, Microstructure and Composition to determine the comparison of violence. The analysis technique used is descriptive analysis that describes the data obtained, then explained in the form of sentences and simple graphs that are easily understood by the reader. From the results of the test, get a comparison of the hardness of the St 60 blade before the Heat Treatment and after the Heat Treatment is 10 kgf.
Teks Lengkap:
PDFReferensi
Akhmad Kharis Nur Zaman,Zulfah,Tofik Hidayat.,Perancangan alat pemotong besi untuk meningkatkan kecepatan potong., Universitas Pancasakti Tegal.
AndreasSurjakaIspandriatno.,RhadianKrisnaputra.,Ketahanan korosi baja di lingkungan air laut., Universitas Gajah Mada.
Ary Setya Kurniawan.,Solichin.,Analisis kekuatan tarik dan struktur mikro pada baja St 41 akibat perbedaan ayunan elektroda pengelasan SMAW.,Tahun 22,No 2.Oktober 2014.,Universitas Negeri Malang.
Asfarizal., Suhardiman.,Analisis kekerasan prilaku baja ringan dengan pendinginan sistem pancaran pada tekanan 20, 40, dan 60 psi., Institut Teknologi Padang.
Carli.,analisis hasil pemotongan press tool pemotong strip plat pada mesin tekuk hidrolik promecam di laboratorium permesinan.,Politeknik Negeri Semarang.
Franz Norman Azzy.,perancangan mesin notching untuk proses sheet metal forming ., vol.1 No 2 juli 2014,.Institut Sains &AKPRIND Yogyakarta.
Rina Dwi Yani.,Tri Pratomo.,Hendro Cahyono.,Pengaruh Perilakuan terhadap struktur mikro logam St 60.,Politeknik Negeri Pontianak.
Sukanto Jatmiko.,Sarjito Jokosisworo.,Analisa kekuatan puntir dan kekuatan lentur putar pada poros St 60 sebagai aplikasi perancangan bahan poros baling baling kapal., Fakultas Teknik UNDIP .
Suratman.,Rancang bangun mesin pemotong zincalume.,Tahun 2016.,Politeknik Negeri Pontianak.
Totok Sugiarto.,pengaruh jenis dan tebal plat terhadap gaya potong pada mesin nibring., vol.1 No 2 juni 2008,.Institut Teknologi Nasional Malang
DOI: http://dx.doi.org/10.29406/stek.v10i2.1544
Refbacks
- Saat ini tidak ada refbacks.